Connecting LimeNET-Micro v2.1 to USB Host: Difference between revisions
Jump to navigation
Jump to search
(Created page with "= Introduction = LimeNET-Micro v2.1 can be connected to USB2.0 host and used as a Software Defined Radio like [https://wiki.myriadrf.org/LimeSDR-Mini LimeSDR-Mini] but with r...") |
|||
| Line 11: | Line 11: | ||
* Install drivers, see chapter [https://wiki.myriadrf.org/LimeNET_Micro#USB_Drivers 5 USB Drivers ] | * Install drivers, see chapter [https://wiki.myriadrf.org/LimeNET_Micro#USB_Drivers 5 USB Drivers ] | ||
* Connect to software, see chapter [https://wiki.myriadrf.org/LimeNET_Micro#Software 6 software] | * Connect to software, see chapter [https://wiki.myriadrf.org/LimeNET_Micro#Software 6 software] | ||
[[File:LimeNET-Micro_v2.1_diagrams v05 USB2 Host.png|center|550px|Connecting LimeNET-Micro v2.1 to USB host ]] | |||
Revision as of 06:29, 15 April 2019
Introduction
LimeNET-Micro v2.1 can be connected to USB2.0 host and used as a Software Defined Radio like LimeSDR-Mini but with reduced sample rate due to USB2.0 connection.
Quick start
- Remove J14 and install J18 jumper. For additional info see chapter 3.3 USB subsystem of LimeNET-Micro v2.1 hardware description.
- Set power selection jumper J27 to "A-USB external" position. Note that in application where LimeNET-Micro v2.1 board requires more power than USB2.0 can supply external power supply has to be used. For additional info for power options see chapter 3.12 Power distribution of LimeNET-Micro v2.1 hardware description.
- Connect microUSB cable to J15 connector.
- Install drivers, see chapter 5 USB Drivers
- Connect to software, see chapter 6 software
