LimeSDR-Core SDR: Difference between revisions

Revision as of 12:30, 6 September 2019

LimeSDR-Core SDR Board

Software defined radio (SDR) and flexible front end– LimeNET CrowdCell builds upon the ground-breaking LimeSDR software-defined radio technology to deliver an app-enabled path covering any standard from IoT to 5G. Use of Limes SDR platform provides the most flexible radio hardware solution that enables LimeNET CrowdCell to be setup in numerous varieties of small-cell configurations. Thus, it is an on-demand network solution, where services could easily shift to data, voice, IoT or any other Telco centric services. LimeNET CrowdCell comes pre-equipped with a flexible front-end module that provides signal duplexing, filtering and amplification.

Features and Specifications

Feature	Description
RF Transceiver	Lime Microsystems LMS7002M MIMO FPRF
FPGA	Intel (Altera) Cyclone IV (EP4CE40F23C8N)
Memory	256 MBytes DDR2 SDRAM
USB 3.0 controller	Cypress FX3 (CYUSB3014)
RF frequency range1	10 MHz – 3.8 GHz
Bandwidth	up to 61.44 MHz
RF connectors	Four MCX connectors (2 TX and 2 RX)
Power Output¹	up to 0 dBm
LTE band support³	All bands up to 3.8 GHz
MIMO	2 x 2
Dimensions	without connectors 125mm x 65mm

¹ LTE modulated output

^* Customers are reminded that any equipment that transmits wireless signals needs to comply with the relevant regulations for that region. This may require that the final equipment is submitted for testing and verification.

Getting Help

If you have questions, the MyriadRF Discourse is a best place to ask for help.

Documentation

LMS7002M (Mask 1) Transceiver Calibration - LMS7002Mr3 calibration guide, using internal MCU
LMS7002M Datasheet (PDF) - LMS7002M RF transceiver datasheet
LMS7002M Programming and Calibration Guide (PDF) - LMS7002M programming and calibration guide

Board Design Files

Here are links to the schematic, PCB project and BOM:

LimeSDR-Core SDR v1.1

Schematic (PDF)

@@ Line 20: / Line 20: @@
 | Bandwidth || up to 61.44 MHz
 |-
-| RF connectors || two SMA female jack
+| RF connectors || Four MCX connectors (2 TX and 2 RX)
 |-
-| Power Output<sup>1</sup>|| up to 23 dBm
+| Power Output<sup>1</sup>|| up to 0 dBm
 |-
-| Noise figure<sup>2</sup> || 0.6 dB
+| LTE band support<sup>3</sup> ||	All bands up to 3.8 GHz
-|-
-| LTE band support<sup>3</sup> ||	2 FDD and 1 TDD
 |-
 | MIMO || 2 x 2
@@ Line 34: / Line 32: @@
 <sup>1</sup> LTE modulated output
-<sup>2</sup> input stage only, optimized for 2.6 GHz
-<sup>3</sup> two FDD and one TDD band support with a single front end board. Band selection done via software. A wide front-end board configuration list.
 <sup>*</sup> Customers are reminded that any equipment that transmits wireless signals needs to comply with the relevant regulations for that region. This may require that the final equipment is submitted for testing and verification.