Lime-GPSDO v1.0 hardware description: Difference between revisions

Democratising Wireless Innovation
Jump to navigation Jump to search
Line 49: Line 49:
[[File:Figure 1 Lime-GPSDO top side components and connectors.png|thumb|center|640px|Figure 1 Lime-GPSDO top side components and connectors]]
[[File:Figure 1 Lime-GPSDO top side components and connectors.png|thumb|center|640px|Figure 1 Lime-GPSDO top side components and connectors]]


[[File:Figure 2 Bottom side components.png|thumb|center|640px|Figure 2 Bottom side components]]
[[File:Figure 2 Bottom side components.png|thumb|center|440px|Figure 2 Bottom side components]]

Revision as of 07:31, 11 April 2019

Lime-GPSDO Board Key Features

The Lime-GPSDO development board provides high stability clock source for timing sensitive applications. Clock frequency is being constantly monitored inside MAX10 FPGA and tuned by PPS signal from GNSS module.

Lime-GPSDO v1.0
Lime-GPSDO v1.0

For more information on the following topics, refer to the respective documents:

  • MAX10 device family, refer to Intel documentation link
  • N20B GNSS module resources link

Lime-GPSDO board features:

  • USB Interface
    • Silicon labs USBXpress Family USB-to-UART bridge CP2102N.
  • FPGA Features
    • MAX10 10M16SAU169C8 device in 169-pin UBGA
    • 16K logic elements
    • 549 Kbits embedded memory (M9K) and 2368 Kbits of user Flash Memory
    • 45 embedded 18x18 multipliers
    • 1 PLLs
  • FPGA Configuration
    • JTAG mode configuration
  • Memory Devices
    • 4Mbit FLASH
    • 128Kbit (16K x 8) EEPROM
  • Connections
    • microUSB2.0 (type B)
    • SMA connectors for clock IN/OUT, time pulse output and GNSS antenna
    • FPGA GPIO header (0.05” pitch)
    • FPGA JTAG connectors (0.05” pitch and side connector)
    • 5V DC power jack and pinheader
    • Backup battery connector for GNSS receiver
    • Clock output pinheader
    • External UART connector
    • External I2C connector
  • Clock System
    • 30.72MHz VCOCXO:
      • Frequency calibration ±0.5ppm;
      • Frequency stability over temperature in still air ±20ppb;
      • Frequency slope ΔF/ΔT in still air ±1.2ppb/°C
    • Possibility to tune VCOCXO by onboard DAC
    • Possibility to use GNSS PPS signal as a reference when tuning VCOCXO frequency
  • Board Size without connectors 50.50mm x 80mm (1.99” x 3.15”)

Board Overview

Lime-GPSDO board version 1.0 picture with highlighted major components and connections presented in Figure 1 and Figure 2. There are three connector types – data and debugging (USB2.0, FPGA GPIO and JTAG), power (DC jack and external supply pinheader), clock source output, GNSS antenna and time pulse output.

Figure 1 Lime-GPSDO top side components and connectors
Figure 2 Bottom side components