Jump to: navigation, search

Difference between revisions of "LimeSDR-Mini JTAG cable adapter"

(7 pin JTAG connector on the board edge)
(7 pin JTAG connector on the board edge)
Line 12: Line 12:
 
Below are shown LimeSDR-Mini JTAG edge adapter schematic. LED is optional component and is required only for power indication.
 
Below are shown LimeSDR-Mini JTAG edge adapter schematic. LED is optional component and is required only for power indication.
  
[[File:LimeSDR-Mini_FPGA_JTAG_adapter.jpg|thumb|center|640px|Figure 1. LimeSDR-Mini JTAG adapter schematic]]
+
[[File:LimeSDR-Mini_FPGA_JTAG_adapter.png|thumb|center|640px|Figure 1. LimeSDR-Mini JTAG adapter schematic]]
  
  

Revision as of 08:52, 10 April 2018

1 LimeSDR-Mini JTAG adapter

To directly program LimeSDR-Mini FPGA Intel MAX 10 (10M16SAU169C8G 169-UBGA), it is needed to connected JTAG adapter (Altera Blaster or equivalent). Standard FPGA JTAG connector has 10 pins in 2x5 configuration with 0.1" (2.54mm) pitch. Standard JTAG connector is too large for such a small PCB as LimeSDR-Mini. For this reason, LimeSSDR-Mini has 2 non-standard JTAG programming connectors:

  • 7 pin (0.1") male header on the board edge (unpopulated)
  • 10 pin (0.05") female header (unpopulated)


1.1 7 pin JTAG connector on the board edge

To use this JTAG connector with standard JTAG adapter you need to make simple JTAG adapter. Below are shown LimeSDR-Mini JTAG edge adapter schematic. LED is optional component and is required only for power indication.

Figure 1. LimeSDR-Mini JTAG adapter schematic


BOM:

1. Header connector (pitch 0.1" (2.54mm));

2. Pinheader (7 pin, pitch 0.1" (2.54mm) ;

3. Flat Ribbon Cable (pitch 0.5" (1,27mm);

4. LED (3mm green)

5. Resistor (1k)


Figure 2. Assembled LimeSDR-Mini JTAG adapter and board


Figure 3. LimeSDR-Mini JTAG adapter connected to the board


Figure 4. LimeSDR-Mini JTAG adapter connected to the board

1.2 10 pin JTAG connector

This connector has standard FPGA JTAG pinout pinout, but smaller pitch (0.05").

Figure 5. Assembled LimeSDR 0.1" to 0.05" JTAG adapter


BOM:

1. Header connector (pitch 0.100" (2.54mm));

2. Female Socket (0.05" (1.27mm));

3. Flat Ribbon Cable (pitch: 0.025" (0.64mm)).