Lime-GPSDO v1.0 hardware description

Democratising Wireless Innovation
Revision as of 11:52, 10 April 2019 by VytautasBuitvydas (talk | contribs) (Created page with "== Lime-GPSDO Board Key Features == The Lime-GPSDO development board provides high stability clock source for timing sensitive applications. Clock frequency is being constant...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Lime-GPSDO Board Key Features

The Lime-GPSDO development board provides high stability clock source for timing sensitive applications. Clock frequency is being constantly monitored inside MAX10 FPGA and tuned by PPS signal from GNSS module.

For more information on the following topics, refer to the respective documents:

  • MAX10 device family, refer to Intel documentation link
  • N20B GNSS module resources link

Lime-GPSDO board features:

  • USB Interface
    • Silicon labs USBXpress Family USB-to-UART bridge CP2102N.
  • FPGA Features
    • MAX10 10M16SAU169C8 device in 169-pin UBGA
    • 16K logic elements
    • 549 Kbits embedded memory (M9K) and 2368 Kbits of user Flash Memory
    • 45 embedded 18x18 multipliers
    • 1 PLLs
  • FPGA Configuration
    • JTAG mode configuration
  • Memory Devices
    • 4Mbit FLASH
    • 128Kbit (16K x 8) EEPROM
  • Connections
    • microUSB2.0 (type B)
    • SMA connectors for clock IN/OUT, time pulse output and GNSS antenna
    • FPGA GPIO header (0.05” pitch)
    • FPGA JTAG connectors (0.05” pitch and side connector)
    • 5V DC power jack and pinheader
    • Backup battery connector for GNSS receiver
    • Clock output pinheader
    • External UART connector
    • External I2C connector
  • Clock System
    • 30.72MHz VCOCXO:
      • Frequency calibration ±0.5ppm;
      • Frequency stability over temperature in still air ±20ppb;
      • Frequency slope ΔF/ΔT in still air ±1.2ppb/°C
    • Possibility to tune VCOCXO by onboard DAC
    • Possibility to use GNSS PPS signal as a reference when tuning VCOCXO frequency
  • Board Size without connectors 50.50mm x 80mm (1.99” x 3.15”)